belt roller

Belt Roller

by

The Job

To begin the correct diameter pipe was selected and cut to size. The internal shaft was then cut to the correct length, and a key machined for the drive motor, the other end was turned to allow the bearing to fit. Two end bushes were then machined to suit the pipe and bearing. The bushes were then TIG welded into the pipe, furthermore the shaft was drawn through, bearings fitted and tightened. Finally the roller was painted.

 

belt rollerbelt rollerbelt rollerbelt rollerbelt rollerbelt rollerbelt rollerbelt rollerbelt rollerbelt rollerbelt roller

Leave a Reply

Your email address will not be published.


PageLines